M-AUDIO DELTA 1010-AI - Manual (Page 2)

Introduction
Congratulations on your purchase of the Delta 1010 ADAT Interface, designed
and manufactured by M Audio. The Delta 1010-AI is a companion to the Delta
1010 PCI Recording System, and when used together, the Delta 1010-AI will
add ADAT Optical 8-channel input and output capability to your Delta 1010.
Please follow the instructions contained in this manual to properly connect the
Delta 1010-AI
to your existing Delta 1010 setup, and to completely understand
the versatility of the Delta 1010-AI. If you have not yet installed your Delta
1010, please refer to the Delta 1010 manual to install and configure the Delta
1010’s PCI card.
Features
• ADAT* I/O for PC(Windows 95/98, NT, Linux) and Apple (MacOS)
computers operating up to a full 24 bit 48kHz.
• Provides ADAT record through and playback using premium 24 bit
converters.
• Simultaneous ADAT recording and computer playback.
• Select between analog and ADAT optical for computer input.
• Select between computer out and ADAT in for routing to the Delta 1010
D/A section.
• Select between computer out and analog in for ADAT input source.
• ADAT In to ADAT Out “Thru” mode.
* ADAT is a registered trademark of Alesis.
What’s in the Box?
Contained in the Delta 1010-AI package, you should find the following:
• This manual.
• Delta 1010 ADAT Interface Module for the Delta 1010.
• 25-pin male to female standard printer cable.
• 9v DC 500 mA center positive power supply.
2