MicroBoards Technology Premium Pro - Manual (Page 13)

DVD Premium Pro Series MICROBOARDS TECHNOLOGY, LLC
13
>HDD1?
(DISC to HDD)
SIMULATION??
(DISC to DISC)
DISC ERASE?
(REWRITABLE)
QUICK ERASE?
7. Press the YES button if you are sure you want to clear the HDD.
8. The hard drive will now be cleared and you will be asked if you want to register another
master to the HDD.
9. Press YES and the Reader drive will eject and you can insert another master to register
to the HDD.
10. Press NO and to exit this menu without registering data to the hard drive partition.
Simulation Disc to Disc
Important:
Simulation is not allowed when using DVD+R/RW media.
1. At the COPY START? (DISC to DISC) menu, press the NO or ▼ button until the display
shows SIMULATION? (DISC to DISC).
2. Place the Master Disc into the Reader drive
3. Place the blank disc(s) into the Recorder drive(s) and wait 10 seconds for the light(s) on
the front of the Recorder(s) to stop blinking.
4. Press YES.
5. The drive trays will open on any recorder without blank discs installed. If you do not want
to make a copy in those drives, close the tray(s), wait for the drive light to go out, and
then press the YES button to start the copy job.
6. The display will now show the progress of the Simulation Copy Job
7. The Recorder(s) will eject the DVD-R discs when the job is complete.
Note:
DVD-R media will NOT be recorded to in Simulation Mode.
Erasing RW media
1. At the COPY START? (DISC to DISC) menu, press the NO or ▼ button until the display
shows DISC ERASE? (REWRITABLE):
2. Load the Recorder(s) with the CD-RW or DVD-+RW media you wish to erase. You can
erase one disc at a time or fill all the Recorders to erase multiple discs at once. All discs
loaded must be of the same type.
3. Press the YES button
4. The next screen asks if you want to perform a Quick
Erase.
If you wish to perform a Full Erase, press the NO
button.
REGISTER 4.0GB
DVD 25%
SIMULATION 4.0GB
DVD 25%
FULL ERASE?