M-AUDIO BX10s - Manual (Page 7)

6 Studiophile BX10s Subwoofer
Appendices
Appendix A - Technical Specifications
Type Bass-reflex active powered subwoofer
Woofer Driver 10-inch composite (treated paper/fiberglass) cone with high-temperature voice coil and damped rubber
surround
Frequency Response 20Hz – 200Hz (-3dB points)
Crossover HP/LP linked filter sweepable from 50-200Hz; 24dB/octave 4th-order alignment
Input Sensitivity 85mV pink noise input produces 100dBA output SPL at one meter with volume control at maximum
Amplifier 240 VA average power into 8 Ω, discrete transistor design
S/N Ratio 86dB (A-weighted)
THD at rated power,
mono mode 0.019% (175 W)
Inputs Two XLR balanced inputs; two TRS balanced/unbalanced inputs
Outputs Two XLR balanced outputs for satellites
Controls Volume/Gain control, 10 dB bass boost switch, sleep mode switch, phase inverse switch, variable crossover
control, subwoofer bypass footswitch jack
Input Impedance 20k ohms balanced, 10k ohms unbalanced
Maximum input level +20dBu
Auto turn off time 15 minutes
Auto turn on input
sensitivity 7.3mV
Protection Over temperature, turn-on/off transient, subsonic filter, external mains fuse, DC protection, over current
protection
Indicator Power On (blue) or Standby/Bypass (Red)
Power Requirements Dual-voltage (selectable by rear-panel switch) for either 100-120V/~50/60Hz or 220-240V/~50/60Hz; powered
via detachable grounded IEC cable
Cabinet Vinyl-laminated MDF
Dimensions 15 in. (h) x 15 in. (w) x 15 in. (d); 38.1 cm (h) x 38.1 cm (w) x 38.1 cm (d)
Shipping Weight 54.6 lbs, 24.75 kg
* Above specifications subject to change without notice
Appendix B – Block Diagram