MURO VISLIDER VL71-FLR - Manual (Page 3)

2
Assembling VISLIDER
1. Assembly and fitting of rod handle
2. Fitting and removal of magazine
Remove the hexagon fitting bolt and the washer
from the handle rod. To the handle rod, fit the
handle bar, the washer and the hexagon bolt in this
order. Tighten the hexagon fitting bolt using the
13mm spanner.
Mount the assembled rod handle on the rear of the
main body. Tighten the two fitting screws using
the 6mm wrench.
To fit the magazine, insert the magazine holder
into the bracket at top end of the main body until
it clicks.
To remove the magazine, withdraw it while pulling
the magazine stopper with fingers.