Miele DA5190W - Manual (Page 14)

Grease filter timer
A timer monitors the hours of fan
operation. The indicator for the
grease/charcoal filter will light red after
30 hours of operation or the
preselected time. The grease filter
must then be cleaned. See "Cleaning
and Care/Grease filter".
After the grease filter has been cleaned
and put in place, the grease filter timer
must be reset.
^ To do this, press the grease/charcoal
filter button for about 3 seconds while
the fan is running.
The indicator will go out.
Charcoal filter timer
Recirculation mode only
The timer for the charcoal filter is not
preset. Please program this timer, see
"Operation/Reprogramming the
charcoal filter timer".
The charcoal filter indicator will light
blue once the selected time has
elapsed. The charcoal filter must then
be replaced and the timer reset.
^ To do this, press the grease/charcoal
filter button for about 3 seconds.
The indicator will go out.
Checking the filter timer
To check the percentage of time
already used:
^ Press the On/Off button to turn the
fan on.
For the grease filter timer
^ Press and hold the grease/charcoal
filter button. The indicator lights red.
For the charcoal filter timer
^ Press the grease/charcoal filter
button twice and hold. The indicator
lights blue.
The number of flashing "–/+" indicators
show the percentage of programmed
hours that have been used.
1 indicator = 25 %
2 indicators = 50 %
3 indicators = 75 %
4 indicators = 100 %
This information will remain stored in
memory in the event of a power failure.
Operation
14