Metra Electronics 99-7407 - Manual (Page 2)

Disconnect the negative battery terminal to
prevent an accidental short circuit. Unclip
the gear shifter/radio trim bezel and remove
the bezel. Remove (4) Phillips screws
securing the factory head unit and
disconnect the wiring. Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the ashtray. Remove (2) screws from the
base of the radio trim bezel. Remove (2)
screws above the climate controls. Unclip
the radio trim bezel and remove. Remove
(4) screws securing the factory head unit
and disconnect the wiring.
Cut and remove all mounting tabs on the
Radio Housing EXCEPT tabs "C". The
mounting tabs can be identified by the
stamped letter on the back of each tab. (see
Fig. A). Cut and remove the side portion of
Faceplate #1. (see Fig. B). Skip to the
Installation Instructions for ALL VEHICLES
on Page #2.
Cut and remove all mounting tabs on the
Radio Housing EXCEPT tabs "B". The
mounting tabs can be identified by the
stamped letter on the back of each tab. (see
Fig. A). Locate Faceplate #2. (see Fig. B).
Skip to the Installation Instructions for ALL
VEHICLES on Page #2.
Cut and remove all mounting tabs on the
Radio Housing EXCEPT tabs "A". The
mounting tabs can be identified by the
stamped letter on the back of each tab. (see
Fig. A). Locate Faceplate #1. (see Fig. B).
Skip to the Installation Instructions for ALL
VEHICLES on Page #2.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) Phillips screws above the radio opening.
Remove the ashtray and (2) screws
exposed in the ashtray cavity. Unclip the top
of the dash trim bezel and remove. Remove
(4) screws securing the factory head unit
and disconnect the wiring.
NISSAN 240SX 1989-94 NISSAN Stanza 1987-89
NISSAN Maxima 1989-94
1 1
1
2 2
2
1 2
2-SHAFT HEAD UNITS: Attach the Faceplate to the Radio Housing. Slide the aftermarket
head unit into the kit and secure with shaft nuts. (see Fig. A)
DIN HEAD UNITS: Cut and remove the shaft supports from the Faceplate and Radio
Housing. Attach the Faceplate to the Housing. Slide the DIN cage into the kit and secure by
bending the metal locking tabs down. Slide the aftermarket head unit into the cage until
secure. (see Fig. B)
ALL VEHICLES
3
Fig. B
Fig. A
Fig. A
"C"
"B"
"A"
"A"
"C"
Fig. A
Fig. A
Fig. B
Fig. B
Fig. B