Magenta MultiView Receiver NEC 600 - Manual (Page 4)

MAGENTA MULTIVIEW™ SERIES
2
1. Specifications
Cable Required: Category 5, 5e, 6 shielded or unshielded twisted pair
Compliance: CE; FCC Class A, IC Class A
Video Support: all supported VESA modes to WUXGA (1920x1200), RGBHV,
HDTV modes including 1080p, 1080i, 720p
(Note: The NEC 600 does not support component, composite
or S-video video signals)
Resolution and
Refresh Rate: At 600 ft. (183 m) or less: a maximum of 1920x1200
Required Source
Impedance: Video OUT: 75 ohms;
Audio models: Audio OUT (if any): 600 ohms maximum
Required Destination
Impedance: Video IN: 75 ohms;
Audio models: Audio IN (if any): 600 ohms minimum
Audio
Characteristics: Full Stereo
Line Level 600 Ohm Unbalanced
Serial
Characteristics: Protocol: Asynchronous; transparent to data format;
3 wire, baud rate of 9600*
Connectors: (2) RJ-45, (1) DB9M (console only, not for SAP use)
Temperature
Tolerance: Operating: 32 to 104°F (0 to 40°C);
Storage: -4 to +140°F (-20 to +60°C)
Humidity
Tolerance: Up to 80% noncondensing
Enclosure: Steel
Power: N/A—power supplied by display.
There are no provisions for external power
Size: 1.6"H x 6.8"W x 11.4"D (4.0 x 17.3 x 28.9 cm)
Weight: 2.2 lb. (1.0 kg)
*The serial baud rate may be changed internally via SAP commands (see SAP
communication Protocol User Manual), however it is recommended to use 9600
baud for best performance.