Monte Carlo Fan Company 5SWR54XXD Series User Manual
Page 4
Twist lower cover plate into place by
twisting in direction of arrow.
Replace 1 screw removed and tighten
all 3 screws securely.
26
Attach blade assembly to motor and
tighten screws securely using screws,
washers, and motor pads in hardware
pack.
24
Install 60 watt bulb with E17 socket.
Attach glass by locating dimples in
light kit with the groves in glass and
twisting clockwise till tight.
27
28
Attach glass by locating dimples in
light kit with the groves in glass and
twisting clockwise till tight.
29
Loosen 2 screws and remove 1
screw. Save screw removed.
25
Match round decorative plates with
holes in blades before attaching
blade arms to blades using the blade
arm screws and washers provided.
23
Remove cover by snaping off from
top or bottom. Install 12V battery
into wall remote. Duracell MN21 /
Eveready A23 / GP 23A all 12V.
30
Lift canopy to ceiling aligning the key hole slots
with the screws on the bottom of the mounting
bracket. Rotate the canopy counter clockwise
to lock in place. Tighten the screws to secure
the canopy. See inset for keyhole shape
22
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
21
white
black
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Orange from fan to Orange from remote
marked Light/up. Blue from fan to blue from
remote marked down light. Black from fan to
Black from remote marked L. White from
house to white from remote marked AC N .
Black from house to Black from remote
marked AC L. Connect all green ground wires
to Ground wire from House.
orange
blue
Green
white
black
House
Fan
20
fuses
Install remote receiver by sliding into opening in
the Mounting bracket. Make sure that the dip
switches on the Transmitter and the Receiver
are set to the same position. See Fig 34 for
remote operation
19