Measurement Specialties PMD-1024HLS - Manual (Page 12)

PMD-1024HLS User's Guide Installing the PMD-1024HLS
When you connect the PMD-1024HLS for the first time, a Found New Hardware popup balloon
(Windows XP) or dialog (other Windows versions) appear as the PMD-1024HLS is detected.
Another Found New Hardware balloon or dialog opens that identifies the PMD-1024HLS as a USB
Human Interface Device.
When the balloon or dialog closes, the LED on the PMD-1024HLS should flash and then remain lit. This
indicates that communication is established between the PMD-1024HLS and your computer
Caution! Do not disconnect any device from the USB bus while the computer is communicating with
the PMD-1024HLS, or you may lose data and/or your ability to communicate with the
PMD-1024HLS.
If the LED turns off
If the LED is lit but then turns off, the computer has lost communication with the PMD-1024HLS. To
restore communication, disconnect the USB cable from the computer, and then reconnect it. This should
restore communication, and the LED should turn back on.
2-3