Miele NOVOTRONIC T 7644 C - Manual (Page 31)

Other problems
Problem Cause Solution
The drying
process goes on
too long or even
switches off.
Even after the lint
screen is
cleaned, the
Filter/Vent
indicator come
on. Please check all possible causes and switch the dryer
off and then on again.
Insufficient ventilation,
perhaps because the
installation space is too
small. As a result, room
temperature may rise. Open the door or window, to
prevent room temperature
from rising.
The ventilation inlets beneath
the door are closed. – Remove the blocking
objects.
Lint screens are plugged
with lint or have been put
back wet after cleaning. – Remove the lint.
– Lint screens must be dry.
Detergent residues, hair and
fine lint may block the
condenser. Inspect and clean the
condenser from time to time.
Laundry was insufficiently
spun. In future, spin textiles in the
washer at a higher rpm.
The dryer is overloaded. Verify the maximum load for
each drying program.
Metal components such as
zippers have prevented the
moisture level of the laundry
from being determined
accurately. – In future, open the zippers.
If the problem recurs, in
future dry garments with long
zippers using the Warm air
program.
The laundry was
not satisfactorily
dried. The load consists of various
fabrics. – Re-dry with warm air.
– Next time, select a suitable
program.
Trouble shooting
31