Merco Savory RB-33VS - Manual (Page 2)

2
INSTALLATION INSTRUCTIONS
Place the RB-33VS in the most convenient location for ease of cleaning, maintenance and general operation. When
installing this unit, avoid locations with drafts, close proximity to grease or vapor-producing appliances, or other high
ambient heat equipment. Allow sufficient overhead clearance for heat dissipation. A minimum of 1” clearance is required
on all sides for proper air circulation.
Before operating this unit, be sure that the following two components are properly installed:
1.
The reflector tray slides in below the conveyor belt and is installed before shipping.
2. The toast receiving tray is packaged separately and must be installed before operating unit. Slide the receiving tray
into the toaster cavity, making sure the lipped end is towards the back. Place the lipped end over the two protruding
pins located at the rear of the toaster cavity. (Figure 1)
WARNING
This toaster must be used with proper voltage as specified on the unit data
Plate located on the rear panel of toaster. Use of any other voltage or
Altering plug will damage unit, void warranty, and may cause injury.
ELECTRICAL SPECIFICATION