MITSUBISHI ELECTRIC WS-73909 - Manual (Page 68)

68 68
Figure 4. Programming the remote to control your DVD/
LDP.
Figure 5. Programming the remote to control your A/V
receiver.
If the remote control has not been
programmed to operate NetCommand ™
and slide switch is set to TV when you
enter an A/V receiver code, VOLUME
and MUTE will control the A/V receiver
rather than the TV. To return volume
and mute control to the TV, set the slide
switch to TV, press and hold POWER
and enter 000.
Some manufacturers may change their
products, or they may use more than
one remote control system. If this is the
case, your remote control may not be
able to operate your VCR, DVD, cable
box, satellite receiver, or A/V receiver.
Part IV: Operation
Programming the Remote Control to Control Non-NetCommand™
A/V Products
After entering the correct codes in each posi-
tion of the remote control, use the slide
switch to select which product will respond
when an operational button is pressed. If
the TV position has not been programmed
to control NetCommand™ and you enter a
code from the A/V Receiver chart while the
slide switch is set to TV, the volume and
mute functions change to match the A/V
receiver. This is useful when using an A/V
receiver with the TV all the time. In all
other cases, only one of the below devices
is allowed for each slide switch position.
TV position (when the remote has not been
programmed to operate NetCommand™):
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR DVD LD Player
DVD position:
DVD LD Player
Cable box VCR
Audio position:
A/V receiver Cable box
Mitsubishi CD player [If you have a Mitsubishi A/V
receiver, the audio position may be used in conjunction with
selected Mitsubishi CD players. Your audio position must be
programmed to 010 ].
P
ro
g
ra
m
m
in
g
t
h
e
R
e
m
o
te
C
o
n
tr
o
l
to
C
o
n
tr
o
l
N
o
n
-N
e
tC
o
m
m
a
n
d
™