Philips Magnavox VRA641AT99 - Manual (Page 44)

44 Multi-Channel Television Sound System (cont’d)
To receive and record programs broadcast in second audio, follow steps 1-6. To receive and record a
program broadcast in stereo, make one of the connections shown, then follow steps 1-6.
6
Press the REC(ord)/OTR button to start recording.
CH3 CH4
RF OUT
ANT.IN
AUDIO
VIDEO
IN OUT OUT R
L
CH3 CH4
RF OUT
ANT.IN
AUDIO
VIDEO
OUT OUT
R
L
IN
IN
1
Press the VCR button, then press the MENU button.
2
Press the PLAY 8 or STOP 9 button to select VCR SET
UP, then press the FF :/OK button.
3
Press the PLAY 8 or STOP 9 button to select
STEREO/SAP, then press the FF :/OK button to select
SAP (for a Second Audio Program) or STEREO,
whichever you prefer.
4
Press the EXIT/STATUS button.
5
Use the CH(annel) 8/9 button to select a channel to
record.
Press the EXIT/STATUS button to access the on-screen status
display and to make sure the program is being broadcast in stereo
or second audio.
If you have a Stereo and a Monitor TV,
use a video cable to connect the VCR’s
VIDEO OUT Jack to the TV’s VIDEO
IN Jack. Use audio cables to connect
the VCR’s AUDIO OUT Jacks to the
Stereo’s AUDIO IN Jacks.
OR, if you have a single-speaker
TV, use an RF coaxial cable to
connect the VCR’s RF OUT Jack to
the TV’s ANTENNA IN Jack.
• If you want to connect the VCR to a
Stereo TV, follow these steps.
1) Connect the antenna or cable
signal to the VCR’s ANT(enna) IN
Jack.
2) Use stereo audio cables to
connect the VCR’s AUDIO OUT
Jacks to the TV’s AUDIO IN Jacks.
3) Use a video cable to connect the
VCR’s VIDEO OUT Jack to the TV’s
VIDEO IN Jack.
• Make sure the TV and the Stereo (if
applicable) are in Line Input or
Auxiliary mode. Please refer to your
TV or Stereo owner’s manual for
Helpful Hints
SELECT , 9 CHOOSE >/OK
→ ON SCREEN MODE ON
BLUE BACKGROUND
ON
TIMER REC SPEED MANUAL
VIDEO STABILIZER
OFF
AUDIO OUT HIFI
STEREO/SAP STEREO
TO END PUSH EXIT
SELECT , 9 CHOOSE >/OK
→ VCR SET UP
TUNER SET UP
INITIAL SET UP
TO END PUSH EXIT