McIntosh XLS320 - Manual (Page 13)

13
Installation, con’t
7. Attach the four rubber bumpers to the bottom long
edge of the XCS350 Loudspeaker System. Refer to fig-
ure 8.
8. Loosen, but do not remove, the three screws securing
the Stabilizer Bar to the back of the XCS350. Refer to
figure 9.
9. Reposition the Stabilizer Bar even with the previously
applied rubber bumpers on the side edge of the
XCS350 enclosure. Refer to figure 10.
10. Tighten the three screws securing the Stabilizer Bar to
keep it in place, but not enough to prevent changing the
angle of the XCS350 in the following steps.
11. The vertical angle of the XCS350 may be changed ±5.5
degrees from perpendicular, allowing the sound to be
directed upwards or downwards to accommodate the
seating arrangement in the room. Refer to figure 11.
This can be accom-
plished by tempo-
rarily loosening the
three screws and
moving the Stabilizer
Bar up or down.
When the desired
angle is achieved,
tighten the three
screws.
12. Rotate the XCS350 Loudspeaker over with the front
facing up, being careful not to damage the Loud-
speaker Drivers. Refer to figure 12.
Figure 12
Fasteners Grommets Grille
13. Locate the Loudspeaker Grille and align the Grille fas-
teners to the Loudspeaker Grommets (four on each
side). Carefully push down to secure the Grille to the
Loudspeaker.
14. Proceed to “Locating the Loudspeaker System” on
page 18.
How to Mount the XLS320 Loudspeaker On the Wall
The supplied On Wall Mounting Brackets allow for two
different mounting positions of the XLS320 Loudspeaker
relative to the wall. The first position is flush mount, with
the Loudspeaker close to and parallel with the wall. The
second position is angle mount, which places the Loud-
speaker further away from the wall and allows for horizon-
tal rotation of ± 30 Degrees. Refer to figure 13.
1. Using the supplied Allen Wrench, remove two screws
from the rear of the XLS320 Loudspeaker System lo-
cated below the recessed connection plate. Refer to fig-
ure 14 on the next page.
Wall
Bracket
Loudspeaker
Bracket
Locking
Screw
Wall Mounting
Screws
Wall
Bracket
Loudspeaker
Bracket
Angled Wall Mounting
Hardware
Flush Wall Mounting
Hardware
Figure 13
Figure 9
Stabilizer Bar Screws
Stabilizer Bar
Figure 10
Figure 11