Motorola CM300 - Manual (Page 30)

28
English
S
CAN
STOP SYSTEM SCAN
Press the preprogrammed Scan button to stop
System Scan (see page 14).
– or –
Note: Your dealer/programmer can preprogram
your radio when exiting System Scan to
automatically revert to the last scan
channel that had activity on it or to
automatically revert to the channel where
scan was initiated.
START AUTO SCAN G
Auto Scan automatically starts scanning once a
channel with Auto Scan enabled is selected.
G
or
H
to select a channel that has been
preprogrammed for Auto Scan by your dealer/
programmer.
STOP AUTO SCAN
G
or
H
to select a channel that has not been
preprogrammed for Auto Scan by your dealer/
programmer.
• The G symbol disappears from the display.
4
D
to select
The display shows the current scan status.
5
G
or
H
until
6 D to select the current setting.
1
D
to enter menu mode.
2
G
or
H
until
3
D
to select
The display shows the current scan status.
4
G
or
H
until
5
D
to select the current setting.
• The G symbol disappears from the
display.
SYS SCAN
SCAN ON
SYS SCAN
SYS SCAN
SCAN OFF
04_Scan.fm Page 28 Thursday, July 24, 2003 4:18 PM