Rear panel controls, Fuse, Ac receptacle – Mesa/Boogie M-pulse Simul State Bass Amplifier User Manual
Page 14: Caution: never block air vents, Page 10
PAGE 10
REAR PANEL CONTROLS:
FUSE:
This is the A.C. Mains Fuse for the M-PULSE REPLACE ONLY WITH A SLO-BLO TYPE FUSE OF THE PROPER
RATING. THIS IS EXTREMELY IMPORTANT, AS THE
M-PULSE DRAWS A SUBSTANTIAL AMOUNT OF CURRENT AT HIGH
OUTPUT LEVEL SETTINGS.
AC RECEPTACLE:
The removable “Euro” Style” A.C. cord that is supplied with the
M-PULSE makes set-ups and tear-downs
after the gig a snap. It also makes de-racking much easier when you wish to remove the unit from a hard wired rack system where all
the A.C. cords have been cabletied in. Additional heavy duty cords are available should you ever need one...simply call us direct and
we can ship one directly to you for a nominal charge, plus shipping cost. Make sure the A.C. cord is firmly in its
socket (receptacle) before powering up the amplifier.
NEVER ALTER THE THREE PRONG POWER CORD IN ANY WAY.
NOTE: NEVER BLOCK OR ALTER AIR ANY OF THE VENTED AREAS ON THE REAR PANEL OF THE AMPLIFIER. Damage to
the unit is imminent and so is the risk of fire.
POWER FUSE
12A
SLO
BLO
120 V~
60 Hz
12 A
FU
SE
F US
E
POWER FUSE
12A
SLO
BLO
120 V~
60 Hz
12 A
FU
SE
F US
E
CAUTION
:
Unplug power
before removing fuse or
bolts holding chassis
WARNING
: To reduce risk of fire or
electric shock, replace fuse with
same type and rating only. Do not
expose this unit to rain or moisture.
WARNING
: To reduce risk of fire or electric
shock, Do not remove cover. No user-
serviceable parts inside. Refer
servicing to qualified personnel.
M-PULSE TM SIMUL STATE BASS AMPLIFIER
TUBE DRIVEN-MOSFET POWER
HANDBUILT IN PETALUMA, CALIFORNIA
CAUTION: NEVER BLOCK AIR VENTS
CAUTION: NEVER BLOCK AIR VENTS
CAUTION
:
Unplug power
before removing fuse or
bolts holding chassis
FU
SE
F US
E
FUSE RATING (USA) 12 A S.B. / 120 VOLTS
CAUTION
:
Unplug power
before removing fuse or
bolts holding chassis
POWER FUSE
12A
SLO
BLO
120 V~
60 Hz
12 A
FU
SE
F US
E
SEND
RETURN
SLAVE OUT
SUGGESTED LOAD
4 OHMS (2 OHM MINIMUM)
SPEAKER OUTPUT
FOOT
SWITCH
LEVEL
DIRECT OUT
POST
PRE
LEVEL