Morphy Richards Pod vacuum cleaner - Manual (Page 6)

6
Cleaning the mesh
and dust filters
IMPORTANT: Every time the pod is emptied,
clean the filters by shaking rigorously, or by
using the brush attachment.
To maintain high suction, the dust filter ‰
should also be washed regularly in warm water,
but do not use detergent.
Allow the filter to dry naturally and ensure it
is totally dry before installing it back into the
cleaner.
A spare dust filter is provided to allow you to
continue using your vacuum whilst the original
filter is washed and dried.
Replacing dust
container
1 Insert the hook at the bottom rear of the
dust pod into the tray on the body. N .
2 Push the dust pod towards the cleaner body
until it clicks into place.
Exhaust filter
After approximately 5 emptyings of the dust
container the exhaust filter should be cleaned.
1 Unclip the exhaust filter cover
È by lifting
the bottom tab. O
2 Remove foam filter.
3 Shake the filter vigorously to remove any
build up of dust.
4 Refit exhaust filter cover by inserting top two
pegs then clip in the bottom tab.
Depending on usage, the exhaust filter
should be replaced approximately every 6
months.
Purchasing
replacement filters
The lifetime of the dust filter is dependant
largely upon usage of the cleaner. Should the
dust filter become damaged or if there is a
noticeable drop in performance even after
washing, it should be changed immediately. Use
only Morphy Richards replacement filters which
can be purchased from specialist retailers or by
calling the number on the front page of this
leaflet.
O