Miele CVA 4062 - Manual (Page 56)

What if the machine does not switch on, even though the "Switch on at"
timer setting is activated?
Possible fault Solution
The System Lock is activated. See "Settings - System Lock".
The display messages are difficult to read.
Possible fault Solution
The contrast or brightness of the
displays are too low / high. Adjust the display contrast / brightness.
See "Settings - Display".
Little or no coffee or espresso is dispensed from the main dispenser.
Possible fault Solution
The main dispenser connector
cap is not positioned correctly,
see "Guide to the machine -
Interior view). Lubricate the cap with the supplied silicone
grease.
No milk or milk froth comes out of the main dispenser.
Possible fault Solution
The dispenser is clogged.
See "Cleaning and Care".
The consistency of the milk froth is not unsatisfactory.
Possible fault Solution
– The air intake tube is clogged.
– The air intake tube is faulty.
– Clean the air intake tube, see "Cleaning and
Care". Any blockages can be removed by
kneading or blowing through the pipe to
remove any potential blockages.
Never use a sharp object to remove
blockages, this could damage the parts.
– Remove the air intake tube and replace it
with the supplied spare part.
Frequently asked questions
56