Mustang Survival MD2085 - Manual (Page 14)

5) Check the housing to be sure it is clear and dry. If necessary, rinse
the inflator with fresh water to remove dirt and salt. Let dry before
going to step 6.
6) Inspect the bobbin. If the bobbin has been fired or damaged, replace
it! Ensure the new bobbin is valid, it must have been purchased
within the last three (3) years. If the bobbin purchase date is
unknown, check the date printed on the bobbin and replace if older
than three (3) years (see Re-arming Your PFD (MD2087), p. 10).
7) IMPORTANT! Bobbin (yellow) must be installed into the HOUSING
(**see figure 9), white side up, aligning the slots on the bobbin with
the ridges inside the threaded housing. The bobbin will slide in easily
if installed correctly.
8) Install cap by screwing clockwise until it meets the housing shoulder.
9) Check the new cylinder/bayonet assembly to ensure the o-ring is in
place and the sensor ring is attached (Fig. 9). Ensure that the CO2
cylinder has not been pierced (Fig. 10).
Solid
Cylinder
Top
Attached
Sensor
Ring
Pierced
Cylinder
Top
Broken
Sensor
Ring
Caution: Do not use
the cylinder/bayonet
assembly if either
the o-ring or sensor
ring is broken,
missing or damaged.
FIGURE 10
IMPORTANT: You will damage the sensor ring if bobbin and
cap are not installed first.
10) Push, and hold, the lever into the inflator housing. The pull-cord
should be situated in the groove (Fig. 11). Install a new cylinder/
bayonet assembly by engaging bayonet tabs in housing, pushing in
then turning clockwise 1/8 turn to a full stop (Fig. 11).
Inflatable PFD Owner’s Manual 12
WARNING: PFD WILL ONLY INFLATE IF CYLINDER IS
TURNED TO A FULL STOP.