Motorola Blue Tooth Phone - Manual (Page 2)

BLUE TOOTH HEADSETS
The Hybrex DK2 Phone Blue Tooth interface will integrate
with many brands of headset, Hybrex have tested and
recommend the following headsets
Motorola HS820
Motorola HS810
Netcom GN6110
• g range
CONNECTION TO PHONE
No physical connection to the DK2 phone is required.
TO PAIR HEADSET WITH DK2 PHONE
Before Pairing:
Please ensure Blue Tooth Headset has had its first
maximum charge as recommended by its manufacturer.
• Hold Headset with Mic Boom closed
• Place Blue Tooth Headset into Pairing Mode by
pressing and holding down the answer key until
LED light comes on
• Open Mic Boom, LED on Headset should remain
on
• Press and hold down the DK2 phones “HOLD” key
until “Pairing” is displayed on phone screen
• Release Hold Key
• Waiting until Blue Tooth Headset LED flashes
rapidly
• Phone and Handset are now Paired
Note: Please ensure you only pair one Blue Tooth Device in
the area of work at any one time
TO ACTIVATE DK PHONE INTO HEADSET MODE
To activate the headset mode on DK2 phone:
• Press [SPK][775] to enable the headset mode.
To cancel the headset mode on DK2 phone:
• Press [SPK][775] to cancel the headset mode.
Z248
TO ANSWER INCOMMING CALLS
Manual Mode
To answer incoming call:
• When DK2 phones rings the Blue Tooth Headset will
beep in your ear
• To answer call press the [Answer] button on the Blue
Tooth headset.
To end the conversation of a call:
• Press the [Answer] button again will end the call
• The Blue Tooth Headset will beep to indicate call
ended and will automatically put DK2 phone to
idle state.
Note:
• If you press [SPK] button on the DK2 telephone this
will also end the call directly. But the Blue Tooth
Headset will be left in Auto Answer Mode”. If left in
this state the next incoming call will be answered
automatically by the Headset.
Auto Mode
Headset will be in active when in this mode, please note the
battery time will be more limited when using this mode
To answer incoming call:
• When DK2 phones rings the Blue Tooth Headset will
beep in your ear once
• The Headset will then answer call
To end the conversation of a call:
• Press the SPK key on the DK2 phone
Note:
• If you press [SPK] button on the DK2 telephone will
also end the call directly. But the Blue Tooth
Headset will be left in Auto Answer Mode”. If left in
this state the next incoming call will be answered
automatically by the Headset.