MicroNet Technology EtherFast 100Mbps Fiber-Optic Adapter SP2515 SERIES - Manual (Page 5)

5. Carefully insert the Fiber Adapter into the chosen slot and
press firmly with proper push to ensure it is fully seated in
the slot.
6. Secure the Fiber Adapter with the screw you saved in step 4.
7. Replace the PC cover.
8. Proceed to “Connecting to Your Network” section.
2.3
2.3 2.3 2.3 Connecting to Your Network Connecting to Your Network Connecting to Your Network Connecting to Your Network
This section describes how to connect the Fiber Adapter to a 100
Mbps fiber-based Ethernet network, which contributes to its
optimal performance.
1. Remove the protective covers from the Fiber Adapter’s
connector.
2. R Prepare a network cable with corresponding connectors for
the two end devices, one end to the Fiber Adapter and the
other to a 100Mbps fiber port on the network hub or switch.
3. Connect the network cable to the connector on the Fiber
Adapter.
4. Connect the other end of the network cable to a
100BASE-FX hub or a switch.
5. When the cable is properly connected to two end devices,
turn on the power to the PC.
6. Check the LNK (Link) LED. The LED will come on when
the Fiber Adapter is receiving a good link signal from the
connected device, a hub or switch.
7. Proceed to next section for installing the network driver.
2.
2. 2. 2.4 44 4 Drivers and Utilitie Drivers and Utilitie Drivers and Utilitie Drivers and Utilities Diskette s Diskette s Diskette s Diskette
The [Divers and Utilities] diskette contains all the popular
operating system drivers.
Novell NetWare (client /server)
Windows NT 3.5, NT4.0
Windows 95/98/2000
Microsoft Client (NDIS 2.0 DOS/OS2)
Windows For Workgroup 3.11
…. and so on
2. 2. 2. 2.5 55 5 Sof Sof Sof Software Installation tware Installation tware Installation tware Installation
Please refer to “Quick Installation Guide”