Magic Chef Garment Steamer - Manual (Page 4)

4
Return appliance to authorized service center for examination, repair
or adjustment.
8) The use of attachments or accessories not recommended or sold by
the manufacturer may result in fire, electric shock or injury.
9) Unplug the appliance from the outlet when not in use, assembling
and disassembling, and before cleaning. Make sure the appliance
cools down completely before assembling, disassembling and
cleaning.
10) Do not let cord hang over edge of table or counter, or touch hot
surfaces.
11) Do not use outdoors.
12) Do not operate the steamer without filling the water reservoir. Always
check the water level before and during operation.
13) Do not lay the hose on the ground or wind it.
14) Do not touch the hot metal parts, hot water or steam to avoid burns.
Use care when turning a steamer upside down, there may be hot
water in the reservoir.
15) Allow the appliance to cool completely for at least 30 minutes and
drain the water tank and water reservoir before storage.
16) Move the appliance by grasping the telescopic pole. Do not force the
casters if they are stuck. Turn off the unit, drain the water tank and
water reservoir before inspecting the casters.
17) Always disconnect the appliance from the outlet before filling or
draining water and when not in use. Be careful to avoid excess water
spilling from the water reservoir.
18) Unplug the unit from the outlet when not in use, when moving unit
from one location to another and before cleaning.
19) Do not place the unit or any parts near an open flame, cooking or
other heating appliance.
20) Do not use extension cords to avoid overheating and risk of fire.
21) No detergent can be added into the water tank or it will cause
damage. Distilled or de-mineralized water is recommended.
22) To reduce the risk of contact with hot water emitting from steam
vents, check appliance before each use by holding it away from body
and operating steam button.
23) Do not allow cord to touch hot surfaces. Let appliance cool
completely before putting away loop cord loosely around appliance
when storing.
24) To reduce the likelihood of circuit overload, do not operate another
high wattage appliance on the same circuit.