English – Muratec SL1000 User Manual
Page 18
User Manual
SL1000
Page 18
English
Operating Instructions
Remove the charger base and AC adapter from the packaging.
Plug the AC adapter cable into the adapter jack located on the rear of the charger.
Plug the AC adapter into an AC outlet
Your charger is now ready to begin charging
Charging starts automatically when the radio/battery is placed into the charger cup. The charging
time is dependent upon the charge status of the battery.
Lighting color
Description
Red During
charging
Green Fully
charged
Extreme cold (under -10°C; 14°F)
Blinking orange
Extreme heat (over +60°C; 140°F)
Blinking red
Error
NOTE: If your battery seems to have no capacity even after being fully charged, completely
discharge it, then fully charge it again. If the battery still does not retain a charge, new batteries
must be replaced.
Safety information
To reduce the risk of shock or injury, familiarize yourself with the correct and safe operating
procedures defined in this manual. Only charge Maxon's batteries in this charger – other battery
types may burst causing personal injury or damage to the charger, battery or radio.
The CH-SL1000-02 desktop charger is rated for indoor use only.
Do not disassemble the charger; incorrect reassembly can cause fire or electric shock.
Do not pull output plug with excessive force.
Do not use the charger when it is covered by objects which impede heat dispersal.
Connect the supplied Maxon adapter only to the voltage supply as specified on it's label.
Unplug the AC adapter from the wall outlet before attempting inspection or cleaning of the
charger.
Do not use solvents such as benzene or paint thinner to clean the charger.
MEMO