Filling with oil, Cooking, General cooking method – Morphy Richards 45362 User Manual

Page 5: Cooking home- battered foods

Advertising
background image

55

55

FILLING WITH OIL

Pour oil into the tank up to the

maximum level indicated

(approximately 2.5 litres of oil).

Lightly smear the inside of the

viewing window with the oil to

inhibit any condensation which

could reduce visibility.

Use good quality liquid

vegetable oil, see getting the

best from your fryer on page 6.

COOKING

WARNING: Never operate

the fryer without oil in the

bowl.

1

Lower the basket and close the

lid.

2

Plug into the mains and switch

the power on at the socket and

switch on the fryer to position

I.

3

The red power light and orange

temperature light will illuminate.

4

Set the variable temperature

control to the required setting,

see ‘frying times and

temperature section’.

5

The fryer is now pre-heating the

oil, the orange temperature light

may go out and come back on

once or twice during pre-heat.

After approximately 15 minutes,

the oil will be at the correct

temperature.

6

Lift the lid.

Do not over fill the basket when

frying, the food must be covered

with the bubbling hot oil.

There are two methods of

cooking in your fryer; one

general method for most food

types and another for home

battered products.

General cooking

method

(with the basket)

1

Place the basket in the raised

position. The basket should

always be in the raised position

when it is to be filled with food.

2

Place the food, which should be

as dry as possible, into the

raised basket. When frying

frozen food, avoid adding ice

particles to the hot oil. Remove

the basket from the fryer, add

the frozen food and shake the

basket to remove excess ice and

frost. The oil temperature and oil

life expectancy will be improved.

3

Lower the basket onto the

basket rest ‚.

4

Lower the lid.

5

Lower the basket to the frying

position.

You can observe the cooking

process by raising the lid or

looking through the viewing

window to observe progress.

6

When the food is cooked, raise

the lid, lift the basket out of the

oil, give it a shake, and place it

in it’s raised rest position for one

minute to drain.

7

Lift the basket out and shake the

fried food into a dish with oil

absorbing kitchen paper.

8

After use, disconnect from the

mains supply and allow to cool.

Wipe any spilt oil from the fryer

body.

You can store the basket in the

oil.

Cooking home-

battered foods

(with the

basket in lowered position)

This method allows for the fact

that if wet batter is placed in the

basket prior to cooking, the food

may stick.

1

Leave the basket in the down

position.

2

Coat the raw food in the batter

and allow it to drain slightly to

get rid of the excess coating.

3

Very carefully, slowly lower the

coated food into the hot oil,

using a suitable implement or

tongs. This allows the batter to

become solid and prevents it

sealing to the mesh of the

basket.

45362 rev1 24/4/08 12:10 Page 5

Advertising