Morphy Richards Essentials Bag Vacuum Cleaner - Manual (Page 4)

44 U UK K H He ellp plliin ne e 00887700 006600 22660044 R Re ep plla ac ce em me en ntt P Pa arrttss 00887700 116677 66663355 IIrre ella an nd d H He ellp plliin ne e 11880000 440099111199
OPERATING THE
APPLIANCE
Assembly A
WARNING: Do not plug in
the cleaner until it is
assembled.
1 Carefully unpack all
components.
2 Lift cleaner body to upright
position.
3 Remove the two screws that are
already attached to the body.
4 From the rear of the cleaner,
align the handle with groove and
slide into the body. If necessary,
use thumb and finger pressure
to slide handle into position.
5 Fasten the handle with the two
screws.
Floor nozzle height
adjustment
B
Before using the cleaner the
floor nozzle height must be set
to the correct height.
Choose the setting which most
closely matches your floor
surface, ie. deep carpet pile,
medium carpet pile, short carpet
pile or hard floor.
IMPORTANT: When using the
attachments the cleaner must
only be used in an upright
position with the carpet height
adjustment knob set to tools
setting.
Note: The height adjustment
only comes into effect when the
handle is released by the handle
release pedal Â.
Using on carpets
1 Place cleaner in its upright
position.
2 Set the carpet height
adjustment knob to the desired
position.
3 Release the mains cable by
revolving the quick release cleat
1/2 a turn and extend the cable
fully.
4 Plug the cable into the mains
socket.
5 Step on the handle release
pedal to release the handle to
the desired position.
6 Press the on/off button to the 1
position.
IMPORTANT: To prevent damage
to carpets, never leave the
cleaner switched on in one
place for an extended period.
• Never have the brushes set too
low such that the cleaner is hard
to push.
Using attachments
Follow steps 1-4 above but set
the carpet height adjustment
knob to the tools setting.
5 Remove the hose connector ›
from the rear of the cleaner. Lift
the hose ¤ from the top handle
hook and push the required
attachment onto the end of the
hose.
• Push the required attachment
firmly onto the end of the hose.
• If additional length is required,
attach one or both extension
tubes between the hose and
tool.
A
B
73342 rev1 13/3/07 15:02 Page 4