Milwaukee 6066-6 - Manual (Page 8)

page 8
USING GRINDING AND CUT-OFF WHEELS
Troubleshooting
Deep scratches and circular marks can result from:
• Uneven pressure
• Using a partially glazed wheel - especially on aluminum applications
• Dirt or loose metal on the workpiece
• Failure to constantly move across surface
Bluish discoloration of metal surface indicates:
• Excessive heat caused by circular motion in a small area
• Excessive pressure
• Use of worn out or glazed wheels
Inspecting Wheels
Always handle wheels carefully to avoid damage. Before installing any
wheel, always inspect it for cracks. If wheel is cracked, discard it to
prevent others from using it.
To reduce the risk of injury, the operator should be in-
structed in the use, care and protection of grinding wheels.
WARNING!
Care of Grinding & Cut-Off Wheels
Installing Grinding Wheels (Fig. 4)
1. Unplug tool and place it upside down on a level surface as shown. Remove any accessories from spindle.
2. Thread flange and nylon washer onto spindle. Attach guard and grinding wheel using Fig. 4 to determine type and order of assembly (See
"Installing, Adjusting, and Removing the Guard" for attaching guard). NOTE: When installing Type 27 or Type 29 grinding wheels, position wheel
nut according to wheel thickness.
Position the guard in the location which offers best control and guard protection. For operating zones that provide maximum protection for the
operator, see "Grinding". NOTE: When selecting Type 11 grinding cup wheels, the guard’s skirt should be adjusted so that no more than 1/8" of
the wheel extends beyond the guard.
3. To tighten, press in the spindle lock button while turning wheel or disc nut clockwise using the spanner wrench provided.
4. To remove grinding wheel and guard, unplug tool and reverse procedure.
Fig. 4
Spindle
Grinding wheels
A. Type 28 with hub
B. Type 27 with hub
Type 29 with hub
C. Type 27 with flange
Type 29 with flange
D. Type 11
Wheel nut
B C D A
Spindle lock button
Guard
E. Type 28
F. Type 27
G. Type 27
H. Type 11
F G H E
Wheel
Hub adaptor
Nylon washer
Flange
Lock washers
S c r e w s
Guard
Grinding and cut-off wheels should be protected from:
• wetness and extreme humidity
• any type of solvent
• extreme changes in temperature
• dropping and bumping
Grinding and cut-off wheels should be stored:
• in an organized way so wheels can be removed without disturbing
or damaging other wheels
• with their safety information
Grinding and cut-off wheels should NOT be:
• dropped
• rolled
• bumped
If any wheel is dropped, rolled, bumped, subjected to extreme changes
in temperature, or has come into contact with solvents or wetness,
discard wheel immediately.