M-AUDIO 10 IN 10 OUT PCI DIGITAL RECORDING SYSTEM WITH S/PDIF DELTA 1010 - Manual (Page 18)

Delta 1010 User Guide 18
|
< S/PDIF In: This input corresponds to the S/PDIF input.
< S/PDIF In (L/R Rev.): This corresponds to the S/PDIF input but swaps the left
and right channels.
< H/W In 1/2 through 7/8: These inputs correspond to the hardware analog
inputs of the Delta 1010 interface.
TIP: To restore the Router/Patchbay to its default settings, select the topmost radio
button in each column.
Hardware Settings Tab
The Hardware Settings tab gives you control over a variety of features of Delta 1010.
These features are grouped into the following sections:
NOTE: Some audio applications may make certain Control Panel settings
unavailable while the application is open. In this case, you will need to adjust these
settings through the audio application itself. This process varies from program to
program, but it is usually done through the application’s “Configuration” or “Audio
Settings” menu. Refer to your audio software’s documentation to learn how to do
this.
< MASTER CLOCK: This section allows you to select the source of the interface’s
master clock. Delta 1010 allows you to select among the following three
sources: Internal Xtal, S/PDIF In, and Word Clock.
If you are using your Delta 1010 by itself, this parameter must be set to “Internal
Xtal” for the interface to work properly. This setting uses Delta 1010’s internal
crystal oscillator as the source of the master clock.
If you have connected a S/PDIF device to your Delta 1010’s S/PDIF input, set
S/PDIF as the source of Delta 1010’s master clock and make sure that the
external S/PDIF device is configured to provide the master clock signal. This will
slave Delta 1010 to the external device’s clock and allow S/PDIF signals to enter
the interface.