MITSUBISHI ELECTRIC Mitsubishi Electric LCD HC6800 - Manual (Page 27)

EN-27
2. INSTALLATION menu
ITEM
SETTING FUNCTION
KEYSTONE ±15 Use to correct vertical keystone distortion.
LAMP MODE STANDARD Select this option when you want to view images in a well-lit room.
LOW Select to moderate the intensity of the lamp. The fan operating sound is
reduced and the lamp lifetime becomes longer.
AUTO POWER ON ON / OFF When ON is chosen, the lamp is automatically lit when the power cord is
plugged in the wall outlet. Choose ON when using the projector mounted on
the ceiling.
The projector is in the stand-by mode when the lamp is off. Use the remote •
control to turn on the lamp.
AUTO POWER OFF OFF / 5 - 60min Use to set the time elapsed before the projector enters the stand-by mode
when there is no signal input from the source.
SPLASH SCREEN ON / OFF Choose ON to display the splash screen when the power is turned on.
BACK COLOR BLUE / BLACK Use to change the color of the screen that appears when no signal is supplied.
IMAGE REVERSE OFF Select when viewing images from the front with the projector installed on the
floor.
MIRROR Select when viewing images projected from the behind of the screen with the
projector installed on the floor.
INVERT Select when viewing images projected from the behind of the screen with the
projector installed on the ceiling.
MIRROR INVERT Select when viewing images from the front with the projector installed on the
ceiling.
TRIGGER OUT SCREEN The trigger output signal (12 V) is output from the TRIGGER terminal when the
lamp illuminates.
ANAMORPHIC The trigger output signal (12 V) is output from the TRIGGER terminal when the
aspect ratio is set to ANAMORPHIC 1 or ANAMORPHIC 2.
OFF The trigger output signal (12V) isn’t output.
TEST PATTERN CROSS HATCH Select to show the test cross hatch pattern.
WHITE Select to show the maximum brightness image.
BLACK Select to show the minimum brightness image.
LENS LOCK ZOOM/FOCUS LOCK Use to enable or cancel the FOCUS LOCK and ZOOM LOCK.
LENS SHIFT LOCK Use to enable or cancel the LENS SHIFT LOCK.
LENS SHIFT RESET Use to reset the position of the lens to the factory setting.
When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW about one minute •
after turn-on.
When the lamp mode is switched, the projected image may flicker. This is not a product malfunction.
•
Do not change the setting of LAMP MODE frequently. •
To cancel the test pattern, press any button. •
IMAGE
REVERSE
OFF
OFF
BACK COLOR
OFF
opt.
STANDARD LAMP MODE
A V MEMO R Y 1
LENS LOCK OK
AUTO POWER
ON
AUTO POWER
OFF
INSTALLATION
TRIGGER OUT OFF
ON ON
BLUE
SPLASH
SCREEN
TEST PATTERN CROSS HATCH
KEYSTONE 0
2. INSTALLATION menu
Menu operation (continued)