Motorola III - Manual (Page 43)

42 General Radio Features Operation
(cont.)
MAEPF-22627-O(G)
MAEPF-22627-A (J) MAEPF-22627-O(D) 42
Conventional Telephone Operation (cont.)
4. When you have finished dialing your number, press
the PTT switch. The display shows “PLEASE WAIT”
while your radio attempts to access the telephone
system.
Note: This is a timed message. If you cannot
access the telephone system (no dial tone heard),
you will have to press the HOME key or the phone
button to hang up, and start again at step 1 of this
procedure.
5. If the access was successful, you will hear a dial
tone. The display will again show the number
dialed.
6. To place the telephone call, press the PTT button
again. The telephone number will be sent out; you
will hear tones as they are being sent. When the
number has been completely sent out, you will hear
either a busy signal or ringing.
7. If the party you are calling answers, carry on with
your conversation in the normal manner. Press the
PTT switch to talk; release the PTT to listen.
Notes:
• After reaching the number you are calling, you
may need to dial an extension number before
you can reach your party. If this is the case,
enter the extension number from the keypad
( M T S 2 0 0 0 I I I m o d e l o n l y ) o r ( i f s o
programmed) use the arrow keys to find the
extension number in the telephone list.
• Many conventional telephone patches will
generate a high-pitched go-ahead tone when
the radio’s PTT switch is released. This is
heard by the land-line party as an indication to
begin talking.
8. When you have finished your conversation, or if the
number you are calling is busy or does not answer,
press the HOME key or the phone button to send
the hang-up code. The radio will return to the home
display.
2 A B C 1 3 D E F
6 MNO 5 JKL 4 G H I
7 P R S 8 TUV 9 W X Y
0
HOME