Motorola DSR205 - Manual (Page 18)

1
8
• On the Installation Settings
menu, choose option 2 (Set
Remote Control Address).
Now follow the instructions
on the Remote Control
Address screen.
• If you have four receivers,
you will have to change the
addresses on three of them:
they will have address of
0000, 0001, 0002, and
0003.
To program your remote control for each receiver, hold down the SAT key on the
remote control until the light flashes. Once the light begins to flash enter the
desired address.
System Status
This is a view-only screen
that displays information
about the status of the
receiver.
Trip Counter. Trip Counter
displays the number of
message updates from your
service provider.
Authorization Screens
Sometimes when you tune to a program, an Authorization screen will appear. It
will fade to black after a short time, it will reappear when:
• The channel or program is locked out because of your parental control setting,
which requires you to enter a password. (If you have not set a password, just
press the ENTER key.)
• The receiver is not authorized.
• A subscription is required to receive the program.
• There is a program blackout in your area.
• There is a technical problem.