MB QUART PAB 2100 - Manual (Page 12)

12
MBQR-1
3 way active, with mono bass
The PAB 5400 5 channel amplifi er contains all the functions neces-
sary to set up a completely self contained 3 way active crossover
system.
Interconnect cable checklist:
Use good quality RCA cables to connect the inputs of channels 1&2
to the full range outputs of the source.
Switch setting checklist:
- INPUT MODE: CH2
- CH 1/2 X-OVER: HP
- CH 3/4 X-OVER: BP
Crossover frequency control checklist:
- CH 1/2 HIGH PASS: 1KHz to 4KHz
- CH 3/4 HIGH PASS: 100 Hz
- CH 3/4 LOW PASS: 1KHz to 4KHz
- CH 5 LOW PASS: 100 Hz
Note that the HIGH and LOW PASS controls of channels 3&4 act as
the bandpass controls.
Please note that these frequency points are suggestions only. Refer to
the loudspeaker manufacturer specifi cations and the section “Setting
up systems after installation for best performance”
Level control checklist:
Refer to the section “Setting up systems after installation for best
performance”
Minimum fi nal loudspeaker impedances: 2 ohm per channel
MBQR-1
Front/rear high pass, with constant
sub bass
Another obvious application for the PAB5400 is to use 4 channels for
front/rear satellites, and the mono channel for constant non faded
sub bass.
Interconnect cable checklist:
Use good quality RCA cables to connect channels 1,2,3&4 inputs to
the front and rear outputs of the source as shown.
Switch setting checklist:
- INPUT MODE: 4CH
- CH 1/2 X-OVER: HP
- CH 3/4 X-OVER: HP
Crossover frequency control checklist:
- CH 1/2 HIGH PASS: 100 Hz
- CH 3/4 HIGH PASS: 100 Hz
- CH 3/4 LOW PASS: N/A
- CH 5 LOW PASS: 100 Hz
Please note that these frequency points are suggestions only. Refer to
the loudspeaker manufacturer specifi cations and the section “Setting
up systems after installation for best performance”
Level control checklist:
Refer to the section “Setting up systems after installation for best
performance”
Minimum fi nal loudspeaker impedances: 2 ohm per channel
AMPLIFIER APPLICATIONS
PAB 5400 5-Channel Amplifi er