Meco Aussie by Meco 4280 Walk-a-bout - Manual (Page 6)

ATTACH LP CYLINDER TO GAS GRILL
1) Make sure the
Control Knob is
in the “LOCK/
OFF”
position.
20 LB. LP CYLINDER
2) Remove the Cylinder
Protective Cap from
the LP cylinder gas
nozzle.
3) Hold 1 lb. LP cylinder upright. Push the LP cylinder
nozzle into regulator nipple and turn clockwise. Keep the
LP cylinder straight while turning it. Make sure the
connection does not cross thread. Hand tighten only until
a snug fit is obtained. Do not use tools.
4) Perform a Leak Test.. (See next page)
1 LB. LP CYLINDER
1) Make sure the Control Knob is in the “LOCK/ OFF” position.
2) Remove the Cylinder Protective Cap from the LP cylinder
gas nozzle.
3) Push the hose end into the regulator nipple and turn the
knurled knob clockwise. Keep the threaded knob straight
while turning it. Make sure the connection does not
cross thread. Hand tighten only until a snug fit is
obtained. Do not use tools.
6
6) If using a 20 lb. LP Cylinder, place
it about 3 ft. directly to the left or
right side of the legs out of traffic
areas. Be sure to leave some
slack in the hose.
5) Align the Coupling nut at
other end of hose and engage
it with the LP cylinder nozzle.
Turn the coupling nut
clockwise and hand tighten.
To reduce the risk of serious bodily injury or death:
· Always place 20 lb. cylinder away from gas grill and
traffic areas to prevent tripping over the hose.
· Always turn off grill and disconnect the gas cylinder
before moving the gas grill.
7) Perform a Leak Test. (See next page)