Miele W1203 - Manual (Page 32)

The program was interrupted and a fault message appears.
Fault message Possible fault Solution
The buzzer sounds,
and the fault indicator
Drain flashes. The drain is blocked. Clean the drain pump and lint
trap. See "Washer care -
Cleaning the drain pump and
lint trap".
The drain hose is too
high. The maximum drain pump
height is 4 ft (1.2 m).
The buzzer sounds,
and the fault indicator
Intake flashes. The water inlet is
blocked. Open the water valve.
The inlet hose filter is
clogged. Clean the filter under running
water and carefully remove
any large particles.
The buzzer sounds,
and the fault
indicators "Intake"
and "Drain" flash. There is a fault. Call the Miele Service
Department.
The buzzer sounds
and the "Status"
indicators "Soak" and
"Rinse" flash. There is a fault. Start the program one more
time. If the fault message
appears again call Miele’s
Technical Service
Department.
To turn off the fault message: Turn off the washer with the "On/Off" button.
Frequently asked questions
28