Section 5 − installation, Installing welding gun, 1. installing welding gun – Miller Electric XLT 185 User Manual
Page 15
Advertising
OM-230 832 Page 11
SECTION 5 − INSTALLATION
5-1.
Installing Welding Gun
804 621-A
1
Drive Assembly
2
Gun Securing Thumbscrew
3
Gun End
Loosen thumbscrew. Insert end
through opening until it bottoms
against drive assembly. Tighten
thumbscrew.
Welding gun must be inserted
completely to prevent leakage of
shielding gas.
4
Gun Trigger Leads
Insert leads, one at a time, through
gun opening on front panel.
Connect female friction terminals to
matching male terminals in unit.
Polarity is not important.
Close door.
Correct
Incorrect
.
Be sure that gun end is tight against drive assembly.
3
Gun Fully Seated
3
Gun Not Seated
Exposed O-rings
will cause shielding
gas leakage.
4
1
2
3
Advertising