Motorola LS1013 - Manual (Page 10)

10
Return the blade guard and center cover to its original
position. Then tighten the hex bolt clockwise to secure
the center cover. Release the handle from the raised
position by pulling the stopper pin. Lower the handle to
make sure that the blade guard moves properly. Make
sure shaft lock has released spindle before making cut.
Dust bag (accessory)
The use of the dust bag makes cutting operations clean
and dust collection easy. To attach the dust bag, fit it onto
the dust nozzle.
When the dust bag is about half full, remove the dust bag
from the tool and pull the fastener out. Empty the dust
bag of its contents, tapping it lightly so as to remove par-
ticles adhering to the insides which might hamper further
collection.
NOTE:
If you connect a vacuum cleaner to your saw, more
efficient and cleaner operations can be performed.
Dust box (accessory)
Insert the dust box into the dust nozzle.
Empty the dust box at the earliest possible.
To empty the dust box, open the cover by pushing the
button and throw away sawdust. Return the cover to the
original position and it locks. Dust box can easily be
removed by pulling out while turning it near the dust noz-
zle on the tool.
NOTE:
• If you connect a Makita vacuum cleaner to this tool,
more efficient and cleaner operations can be
performed.
CAUTION:
• Empty the dust box before collected sawdust level
reaches the cylinder part.
1. Blade case
2. Arrow
3. Saw blade
4. Arrow
1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
5. Spindle
1. Center cover
2. Hex bolt
3. Socket wrench
4. Blade guard
1. Dust nozzle
2. Dust bag
3. Fastener
2 1 4 3
001534
1 2 4
3
5
001786
3
1
2
4
001532
3
1 2
001536
1. Dust box
2. Cover
3. Button
1. Cylinder part
2. Dust box
3. Sawdust
1. Cylinder part
2. Dust box
1
2 3
006793
1
2
3
006792
1
2
006794