Mabe Canada GWS04 - Manual (Page 7)

7
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Care and Cleaning
Care and cleaning.
www.GEAppliances.ca
If the power fails, open the door as
infrequently as possible to maintain
the temperature. A gradual rise in
temperature should not have any
adverse effect on the wine.
If it is extremely hot, you may want to
unload the wine from the wine chiller and
move the wine to a cooler location until
power is restored.
When power is restored, the controls
automatically are set to the Factory Setting
50°F (10°C). If needed, reset the controls
to the desired setting.
In the Event of a Power Failure
Unload the wine, then secure the racks
and door by taping them in place to
prevent damage. Be sure the wine chiller stays in an upright
position during the move.
Preparing to Move
Replacing the light bulb (available on some models)
Unplug the wine chiller.
If the door is locked, unlock it.
The light bulb is located behind the Light Shield in the ceiling of
the wine chiller near the front. To remove the light shield, remove
Screw.Gently pull down on the bottom of the Light shield to release
it.
Unscrew the light bulb from the Socket.
Replace with a 10 watt, 120 volt refrigerator bulb. This type of bulb is
available at most hardware and automotive parts stores.
WARNING:
Using a bulb rated higher than 10 watts may damage
the wine chiller
Attach the Light Shield to the Bulb Housing with Screw .
Plug the wine chiller back in.
2
3
4
5
6
7
C
LED Refrigerator Lights (available on some models)
An authorized technician will need to
replace the LED light