Muse electronic Model Eleven - Manual (Page 4)

4
Setup Menu
If your Model Eleven will be used only to play
standard CDs no setup will be required. If,
however, you intend to play any of the higher
performance formats such as DVD-V, DVD-A or
SACD, you will need to configure the Model
Eleven for your system. In order to setup the
Model Eleven a video device will be required to
view the various menus. Once configured, a
video device is not required for day-to-day
operation, though a video device may be helpful.
To enter the setup menu, press the “Shift” button
located on the lower left corner of the multi-
function remote. This will cause a blue LED to
illuminate on the front panel of the Model
Eleven. This LED indicates that all commands
will follow the blue labels on the multi-function
remote.
To access a red command, press the “Release”
button on the multi-function remote; this will
cause the front panel LED to extinguish and the
Model Eleven will now execute the commands in
red.
With the blue shift LED on the front panel
illuminated, press the “Standby” button, which is
located in the upper left corner of the multi-
function remote. This will cause the Model
Eleven to wake up and enter its operational
state and will extinguish the shift LED on the
front panel.
To access the setup menu, make certain that
your video device is on and set to the proper
input to view the Model Eleven (see cabling
requirements under the section titled “Setup”).
Press the “Shift” button on the remote (blue LED
illuminates) followed by the “Action” button on
the remote. You will now see a menu of six
different groups of settings for the Model Eleven.
The upper left group titled “Audio Settings” will
be highlighted. Any of the six submenus can be
selected by navigating around the display using
the four remote control navigation buttons.
These buttons are labeled “Up”, “Down”, “Left” &
“Right” and are labeled in red. Since all four of
these buttons are labeled red, you must make
certain
that the Model Eleven is not in shift
mode. Looking at the front panel and
determining if the blue shift LED is illuminated
can confirm this. Since your last command was
“Action” which is labeled in blue, you will need to
deactivate the shift mode. This is accomplished
by pressing “Release” on the multi-function
remote and verifying that the blue shift LED has
been extinguished. Now is a good time to
practice navigating the on screen menu choices
using the four remote buttons.
When you are finished, select the block titled
“Initial Settings” by first navigating to and
activating this button by pressing the “Select”
button (located in the middle of the four
navigation buttons).
Initial Settings
A submenu titled “Initial Settings” will appear on
the video device. This page contains a column
of settings on the left side of the screen and a
list of sub-submenu and corresponding choices
on the right side of the screen.