Miele TOUCHTRONIC W 3039 - Manual (Page 51)

Shortening the door panel
The door panel can be shortened to
match the height of the adjacent
cabinetry.
The measure X equals the space from
the bottom of the washer door to the
bottom of the adjacent cabinet.
^ Cut the bottom of the door panel with
a jigsaw according to X.
^ Cut the side decor bars with a
hacksaw.
Installation
^ Open the door.
^ To remove the door panel unscrew
the 10 screws (arrows) from the door
panel.
^ Remove the three decor bars from
the door panel by removing the
screws.
^ Cut the bottom of the door panel and
the two side decor bars by X.
^ Drill four holes into the door panel to
fix the lower decor bar.
^ Install the decor bars and the door
panel.
To install a decor panel, check if it
also needs to shortened.
Installation
47