Monitor Audio SILVER RXW-12 - Manual (Page 7)

monitoraudio.co.uk 11 Silver RXW-12 10
speCIfICatIon
Low frequency limit:- 27Hz (EQ1) 21Hz (EQ2)
Upper frequency limit:-
40 – 120 Hz Variable
Low pass filter alignment:- Active 4th order 24db/octave (two-stage filter)
Cabinet Specification: - Sealed Cabinet of 25mm M.D.F construction with internal
bracing
Amplifier Output:- 500 Watts (RMS) 1000 Watts (Peak)
Amplifier classification:- Class- D Digital amplifier
Driver compliment:- 1 x 12” C-CAM ® subwoofer driver featuring triple suspension
and 3” long throw voice coil
Dimensions:- Cabinet: 340 x 340 x 380mm
(H x W x D) 13 3/8 x 13 3/8 x 14 15/16 Inches
Inc Amp and Driver: 340 x 340 x 410mm
13 3/8 x 13 3/8 x 16 1/8 Inches
Weight (unpacked):-
Input Impedance: - 20K Ohms
Mains input voltage:- 110 - 120 Vac / 220 - 240 Vac 50/60Hz
(Electronically Auto selected)
C-CAM® is a registered trade mark of Monitor Audio Ltd
trouble sHootIng
Should you experience any technical, or set-up problems with your subwoofer please check the
Trouble Shooting Guide below:
My subwoofer will not turn on/no power.
• Is the LED illuminated on the back of the unit? If not, then check your mains lead is
properly connected both at the subwoofer and at the mains outlet. Also check the fuse of
the mains plug (where fitted) and also the fuse in the subwoofer. See page 6 & 8 for further
information on changing the fuse and it’s location.
• Is the LED on the back red? If so, you have power going to the unit. It could be that there
is no signal, or the 12v trigger is connected and the source not turned on (see below).
• Have you got the 12v trigger connected? If so, the subwoofer will not power up until the
source is powered up.
• Has it got a signal going to it (12v trigger not being used)? If so, is the Power Mode Switch
in the Auto or On position, and the signal source is turned on? Try adjusting the volume
level of the source.
If it still does not turn on/ power up, please contact your local dealer/ distributor or Monitor Audio
immediately.
No sound from subwoofer.
• Is the LED on the back red or green? If it is red, then the unit hasn’t actually turned on.
See above suggestions. If it is green, then your unit is powered up and turned on. Check
further suggestions below.
• Are the signal leads connected correctly? Check these. If possible, check with a second,
known to be working set.
• Is the volume level just very low?
If it still does not output a signal, please contact your local dealer/ distributor or Monitor Audio
immediately.
RXW12 manual.indd 10-11 18/08/2009 10:04:08