Marshall electronic V-R201-IMD-TE - Manual (Page 17)

17
On-Screen Menu (continued)
DEINTERLACER SUBMENU
Use the Deinterlacer submenu to control the type of deinterlacing performed on interlaced input signals.
■ Deinterlacer Mode
User the Deinterlacer Mode option to set the type of deinterlacing algorithm used:
• In Auto mode, the deinterlacer defaults to Motion Adaptive mode (see below), but uses Film Mode (see below)
whenever a film cadence is detected. This is the optimum deinterlacing mode for best picture quality and should
be used whenever possible.
•
In Motion Adaptive mode, the image processor uses a motion adaptive de-interlacing algorithm. Film cadence
detection is disabled. Motion adaptive interlacing uses a variety of real-time algorithms to perform the best
possible deinterlacing based on the content.
•
In Field to Frame, each incoming field is scaled to a full progressive frame by the scaler. It is normal for the
image to appear vertically “bouncy” or as shaking.
• In Interpolate (Bob) mode, each field is scaled to a full progressive frame by interpolating the missing lines from
the adjacent lines. It is normal for the image to appear vertically “bouncy” or as shaking.
• In Static Mesh (Weave) mode, the Deinterlacer combines or “weaves” each pair of fields into a progressive
frame. It is normal to see jagged artifacts on fast-moving edges.
System Configuration Submenu