MITSUBISHI ELECTRIC XD50 - Manual (Page 13)

E-12
5m / 16.4 feet
30 °
50 °
50 °
30
°
30
°
30 °
20 °
20 °
4m/13.1 feet
7m / 23 feet
4m/13.1 feet
4m/13.1 feet
4m/13.1 feet
Preparing the Remote Control
Button Battery Replacement
Using the remote control for the first time
The battery compartment is fitted with a transportation insulation sheet at the time of shipping. Pull
out the sheet and remove it. The remote control is now ready for use.
Replacement Method
1 Insert the tip of a ballpoint pen
or some other pointed object
into the hole of the battery
holder, then pull out to open. 2 Remove the old battery and in-
stall a new button battery with (+)
side facing upward in the battery
holder. 3 Insert the battery holder into the re-
mote control and push in until the
battery holder closes with a “click”
sound.
CR2025
M n O 2 - L iCELL 3 VO
LT S JA
PA NH
CR2025
CR2025
M
n O 2 - L iCELL 3 V O LT
S JA PA
NH
CR2025
Purchase a CR2025 type battery for replacement.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type (CR2025) recommended by the manufacturer.
Dispose of used batteries according to your local regulations.
Remote Control Range
Point the infrared transmitter of the remote control toward the remote control sensor located at the front
or rear of the main unit and operate.
Reception of the remote control signal should generally be possible within the range illustrated below.
Side View
Top View
Remote control in-
frared transmitter
Remote control in-
frared transmitter
Remote con-
trol sensor
Remote con-
trol sensor