Mitel 8620 - Manual (Page 22)

Getting Started
Page 8 Mitel ® 8620/8622 IP Phone User Guide – Issue 14, June 2010
Headset Instructions
When using a headset, press (Speaker) to connect to or disconnect from calls.
If you have both a headset and a handset connected to your IP phone and you are using the
headset, you can quickly transfer audio to the handset by lifting the handset from the cradle.
Press (Speaker) to transfer the call back to the headset before replacing the handset in the
cradle.
To connect and activate the headset:
1. Insert the headset jack into the Headset port located on the back of the IP phone. See
“Phone Signals” on page 7 .
2. Dial 317 to turn the headset on. HEADSET MODE ON appears.
To turn off Headset Mode and activate the handset and speakerphone:
Dial 317. HEADSET MODE OFF appears. The handset or speakerphone is now
activated.
NOTES
The headset must be hearing aid compatible (HAC).
If your headset has a power-saver mode, make sure the system administrator has
enabled the “Headset Connect Tone” feature. If this is not enabled, you may miss
the first few seconds of an incoming call.