Marantz DLPTM VP-12S3/VP-12S3L - Manual (Page 13)

ENGLISH
7
1. Take the cover off the battery case on the remote control
backside.
2. Insert two AA size batteries.
Make sure the polarities match the + and – marks inside
the battery compartment.
3. Reattach the battery case cover as before.
CAUTION
– The available battery types are limited: manganese dry cell
and alkaline dry cell.
– Do not mix different battery types.
– Do not mix old and new batteries.
– Only batteries of the same type are to be used.
– Remove exhausted batteries from the Remote Controller.
– Do not attempt to recharge non-rechargeable batteries.
– Do not use rechargeable batteries.
– Batteries are to be inserted with the correct polarity.
– The supply terminals are not to be short-circuited.
– Never throw batteries in a fire or attempt to open up its outer
casing.
– If the user does not intend to use the Remote Controller for
a long time, remove the batteries.
– Keep away from heat.
– Do not be subjected to strong shock.
– Do not be subjected to moisture. If the unit gets moistured,
wipe it off immediately.
– The Remote Controller operation may not function if the
projector’s IR sensors are exposed to direct sun light or
strong artificial light, or if there is an obstacle between the
IR sensors and the Remote Controller.
Preparing the Remote Controller
™4 USER button (
☞
P.32)
Selects the user mode.
The user mode is for enjoying images at a user-selected
gamma curve.
Every time the button is pressed, the selection rotates in the
order of User A1
➔ User A2 ➔ User A3 ➔ User B1 ➔ User B2
➔ User B3 ➔ User C1 ➔ User C2 ➔ User C3.
For more information on how to select gamma curve ➔ (
☞
P.32)
™5 DYNA. button (
☞
P.32)
Select the Dynamic picture mode.
Dynamic mode is good for visually dynamic pictures.
Every time the button is pressed, the selection rotates in the
order of Dynamic 1
➔ Dynamic 2 ➔ Dynamic 3 ➔ Default.
Operate the remote controller within a distance of
approximately 5m from the IR sensor (remote sensor) on the
projector.
Remote control operation may not be possible if the remote
control unit’s transmitter is not pointing in the direction of the
remote sensor or if there is an obstruction between the
transmitter and the remote sensor.
60
150
5m
5m
60 5m
60 5m
VP-12S3
VP-12S3
60
5m
VP-12S3
Remote Controller Operational Range
Remote
Controller
Remote
Controller
Remote
Controller
Remote
Controller
Remote
Controller
AA size batteries
Battery case cover
Battery case cover