MB QUART SCR - Manual (Page 23)

Section 5
21
Uneven Cut on Flat
Lift worn from blade Replace blade
Ground - Wavy
High-Low
Blade upside down Mount with cutting edge toward
Appearance,
ground
Scalloped Cut, or
Rough Contour
Deck plugged, grass accumulation Clean underside of deck
Too much blade angle (deck pitch) Adjust pitch and level
Deck mounted improperly See your authorized SCAG dealer
Bent spindle area See your authorized SCAG dealer
Dull blade Sharpen blade
TROUBLESHOOTING (CONT'D)
Sloping Ridge Across
Tire pressures not equal Check and adjust tire pressure
Width of Cutting Path
Wheels uneven Check and adjust tire pressure
Deck mounted incorrectly See your authorized SCAG dealer
Deck not level side-to side Check for level and correct
CONDITION CAUSE CURE
Uneven Cut on
Uneven ground May need to reduce ground speed,
Uneven Ground -
raise cutting height, and/or change
Wavy Appearance,
direction of cut
High-Low Scalloped
Cut, or Rough Contour
Width of Deck
SGB020
Width of Deck
SGB021
Width of Deck
SGB023