M&S Systems S150W - Manual (Page 5)

visually or by using a musical source to determine the best sound
coverage for the listening area. To position the tweeter, press at the
outside edge of the tweeter cone area. (DO NOT PRESS ON THE
CONE DIRECTLY). Install the metal grille to complete the speaker
installation.
Step 5. Follow the instructions with the volume control and amplifi er
to complete the installation.
Figure 1
SPEAKER INSTALLATION FOR EXISTING CONSTRUCTION
For existing construction, use the same guidelines that apply for
new construction with the following precautions. It is very important
to determine what is in the wall space that you will open to install
the speakers. Check for standard spacing (16” on center preferred)
so you will not need to cut studs and check the wiring path to the
volume control and amplifi er. Avoid 120V wiring and air return duct
and pipe. Proper speaker spacing is also critical to a good system.
The only difference between new and existing construction is the
order in which the process is done (steps 1, 2 and 3). In existing
construction the speaker hole is cut, the wire is run to the volume
control box, and the speaker is connected to the wiring and installed
in the wall. You are ready to complete the process using steps 4 and
5 for new construction.
4 of 7
CAM-LOCK MOUNTING TAB
(6 PLACES)
FACE VIEW OF MOUNTING TAB
115913
IMAGE 5 OF 8