Marshall electronic SD/HD VIDEO LCD MONITOR V-R151DP-AFSD - Manual (Page 13)

13
On-Screen Menu (continued)
VIDEO CONFIGURATION SUBMENU (continued)
■ Aspect Ratio Settings
Use to switch between 4:3 and 16:9 aspect ratios.
As the V-R151DP-AFHD monitor has a native resolution of 1024 x 768 RGB pixels, incoming images are automatically
scaled to fit the screen:
• In 4:3 mode, images are scaled up or down to fill the entire 4:3 screen (1024 x 768).
• In 16:9 mode, images are scaled to fill the maximum 16:9 portion of the screen (1024 x 576), with black bars filling
the remainder of the screen.
Note: The aspect ratio setting is ignored when Pixel-to-Pixel ™ mode is enabled.
■ Scanning Modes
Use this setting to switch between normal and underscan modes:
• In normal scan mode, the active portion of the video signal is displayed on the screen, with 0% overscan.
• In underscan mode, area around the active video area is displayed on the screen, resulting in blanking intervals
being shown around the perimeter of the active image. Use this mode to clearly view the edges of the active video
area.
■ Delay Modes
Use this setting to enable one of three delay modes (H/V, H, V):
• In H/V delay mode, both horizontal sync and vertical sync are delayed, resulting in both horizontal and vertical
blanking periods being shown on the screen.
• In V delay mode, vertical sync is delayed so that the vertical blanking period is displayed on screen.
• In H delay mode, horizontal sync is delayed so that the horizontal blanking period is displayed on the screen.
Note: Delay modes are only available in normal scan mode.
4:3 Mode 16:9 Mode