Metra Electronics 99-7310 - Manual (Page 2)

2 1
1
2
ALL VEHICLES
Disconnect the negative battery terminal to prevent an accidental short circuit. Open the
cupholder and remove (2) Phillips screws exposed. Lower the glove box and detach the vent
cable exposed. Reach under the driver's side dash and detach (2) vent cables located above
the accelerator. Unclip the dash trim bezel and remove. Remove (4) screws securing the
factory head unit and disconnect the wiring.
Snap the ISO Brackets over the mounting tabs on the Radio Housing.
3
5
Re-connect the battery terminal and test the unit for proper operation. Mount the head uni t/kit
assembly to the sub-dash with (4) Phillips screws previously removed in step #1.
4
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Slide the head unit into the Radio Housing, align
the holes in the head unit with the holes in the
Housing and mount the unit with the screws
supplied with the unit.