Marshall Amplification MG15MSII - Manual (Page 5)

1. MAINS INPUT Connector
The MG amplifier is provided with a detachable
mains (power) lead which is connected here.
The specific mains input voltage rating that your
amplifier requires is clearly indicated on the
back panel. Before connecting to the mains for
the first time please make sure that your
amplifier is compatible with your electricity
supply.
2. LOUDSPEAKER Outputs
Connect the two loudspeaker cabinets
provided to the speaker outputs using the
speaker leads supplied.
If you would like to use your MG15MSII
amplifier head with another speaker system
(such as a full size 4 x 12" cabinet), ensure that
the amplifier is provided with a total load equal
to or greater than 8 ohms.
Always use a non-screened Marshall
approved speaker lead when connecting an
extension cabinet to these units.
MG15MSII Rear Panel Features
WARNING!: SHOCK HAZARD. DO NOT OPEN. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. THIS APPARATUS MUST BE EARTHED.
AVIS!: RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR. POUR EVITER LES RISQUES D’INCENDIE ET
DE DECHARGES ELECTRIQUES, N’EXPOSEZ JAMAIS CET APPAREIL A L’HUMIDITE OU A LA PLUIE.
CONNECTER CET APPAREIL A LA TERRE.
CAUTION!: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
ATTENTION!: POUR EVITER LES RISQUES DE DECHARGES ELECTRIQUES, NE PAS OUVRIR LE
COUVERCLE. CET APPAREIL NE COMPORTE AUCUNE PIECE SUSCEPTIBLE D’ETRE REPAREE PAR VOS
SOINS. FAITES TOUJOURS APPEL A UN TECHNICIEN QUALIFIE POUR TOUTE REPARATION.
OUTPUT: 15 WATTS RMS INTO 8 Ω
!
Mains Input
120V ~ 60Hz
45 Watts
16Ω LOUDSPEAKER OUTPUTS
( WARNING: DO NOT USE WITH A LOAD OF LESS THAN 8 Ω )
( ATTENTION: NE PAS UTILISER AVEC UNE IMPEDANCE INFERIEURE A 8 Ω )
WARNING!: RISK OF HAZARDOUS ENERGY
AVIS!: ENERGIE ELECTRIQUE DANGEREUSE!
!
Designed, Engineered & Quality Controlled by
Marshall Amplification plc, Bletchley,
Milton Keynes, England.
Made in Korea
1 2
HELPFUL HINT: for ‘silent’ recording merely
plug an unconnected jack plug into the
headphone socket and you’ll disconnect the
MG15MSII speaker cabinets.
12. EMULATED HEADPHONES jack
Plug your headphones here for a killer
speaker emulated sound! Doing this mutes
your MG15MSII speaker cabinets for ‘silent’
practice.
13. POWER Switch & LED
The power switch turns your amplifier on and
off. The LED will be lit when your amplifier is on
and will not be lit when the amplifier is switched
off.
Note: Before connecting to the mains
electricity supply, always ensure that your
amplifier is compatible with your electricity
supply, as detailed on the rear panel.
Please ensure the amplifier is switched off
and unplugged from the mains electricity
supply before being moved.
4
ENGLISH
MG15MSII Hbk multi 120V 1/7/02 9:21 am Page 4