Miele G 6XX - Manual (Page 15)

Setting the machine for water hard-
ness level 4.1 - 12.6 mmol/l (23°d -
70°d):
^ Using the programme selector but-
tons
% (19) keep pressing down
through programme position 6 until
the "Wash/Rinse" (16) indicator light
flashes.
You are now in the second program-
ming level.
^ Use the programme selector buttons
(19) to select the programme that
corresponds to your water hardness
level (see Table 2).
The indicator light next to the
programme selected (14) and the
"Wash/Rinse" indicator light (16) will
start to flash.
Table 2:
°d
(German
scale)
mmol/l Programme
position
23 - 35 4.1 - 6.3 1
36 - 70 6.5 -12.6 2
^ Press the "Start/Stop" button (17)
twice.
The programmed water hardness level
is now stored in memory.
^ Switch the dishwasher off using the
"On/Off" button (13).
Checking the programmed water
hardness level
^ Switch the dishwasher off using the
"On/Off" button (13).
^ Press the "Start/Stop" button (17) in
and whilst holding it in switch the
dishwasher on using the "On/Off" but-
ton (13).
Release the "Start/Stop" button within
two seconds.
The water hardness level programmed
into the machine is indicated by a light
being on next to one of the
programmes.
There are two programming levels.
If the "Wash/Rinse" indicator light (16) is
on, you are in the first level
(see Table 1).
If the "Wash/Rinse" indicator light (16) is
flashing, you are in the second level
(see Table 2).
^ Switch the dishwasher off using the
"On/Off" button (13).
Before using for the first time
15