MITSUBISHI ELECTRIC QA6ADP - Manual (Page 10)

9
4. PART NAMES AND SETTING
4.1 Part Names
This section describes part names of the QA6ADP.
1)
6)
2)
3)
4)
3)
7)
9) 8)
5)
No. Name Application
1) Extension cable
connector
Connector for sending/receiving signals to the main
base unit or the other extension base unit and
connecting an extension cable.
2) Stage number
setting connector
Connector for setting the number of extension stages.
3)
Adapter module
mounting screw
(M3 screw)
Screw for mounting this adapter module on the
extension base unit.
4) Adapter module
mounting bracket
Bracket for mounting this adapter module on the
extension base unit. Utilize screws used in the
extension base unit. (Included parts)
5) Mounting bracket
fixing screw
Screw for mounting an adapter module mounting
bracket on the extension base unit. (Included parts)
6)
Base side stage
number setting
connector window
Window is transparent so that a stage number setting
connecter of the extension base unit side can be seen.
7) Extension base unit
mounting connector
Connector to be connected to the A extension cable I/O
connecter of the extension base unit.
8) Board fixing screw
Screw for mounting this adapter module on the
extension base unit. (Included parts)
9) Mounting guide
Guide for positioning an extension base unit mounting
connector by inserting this into a cover fixing square
hole of the extension base unit at the time of mounting.